Putting up scaffold is its own trade. A painter, roofer, or stucco crew should spend their day on their work, not on leveling base plates and pinning guardrails. Our installers do the scaffold so your people can start on the wall.
We set up on concrete, dirt, slopes, and tight side yards. Before we leave, we walk the scaffold with you and show you where the access points are.
What is included
- Setup on flat, sloped, or soft ground
- Guardrails, toe boards, and ladder or stair access
- Walkthrough before your crew climbs
- Changes and moves during the job
- Full teardown and haul-off at the end
Built for the ground it sits on
A lot of Inland Empire lots are not flat. Hillside homes in Yucaipa and Alta Loma, side yards with a grade change, and fresh fill on new tracts all need a base that will not settle. We use mud sills, base plates, and screw jacks to bring each leg to level before the first frame goes up.
Ready for inspection
Cal/OSHA expects a competent person to check scaffold before each shift. We build it so that check is simple: planked decks, guardrails at the right height, and clear access. We are happy to walk your foreman through it on day one.
Teardown on your timeline
When the last coat is on, call us. We take the scaffold down, load it out, and leave the site clean. If part of the wall is done early, we can pull those sections first and leave the rest standing.
Installation & Dismantling questions
How long does it take to set up scaffold on a house?
A typical two-story home takes one day. Bigger buildings, hillside lots, and jobs with canopies or stair towers take longer. We give you a setup date when we quote.
Can you move the scaffold partway through the job?
Yes. Many jobs go one wall at a time. We can move bays to the next elevation when your crew is ready.
Who inspects the scaffold once it is up?
Our crew checks it at handover. After that, your competent person should inspect it before each shift and after anything that could affect it, like high wind or an impact.